How to Start a Manual Regeneration on a Meter Water Softener(Pre C30)
Starting a manual regeneration on your meter water softener is a simple process.
This video will show you exactly how to do it.
This method will only work for water softeners that have C29 or below on the back of their control valve as seen in the picture below, if you have a post C30 model please follow this link to the appropriate video.
Here’s how to perform a manual regeneration on Water2buy meter water softeners.
A manual regeneration is recommended in the following scenarios.
You are experiencing hard water after your installation.
Your unit is not using salt.
And simply just to check if your unit is working correctly.
When starting a manual regeneration
Make sure the backwash knob is at the ‘SERV’ position.
Unlock the screen by holding the ‘menu’ button.
Press the ‘menu’ button again to cycle through the menu options.
Use the scroll down button to select ‘METER’
Press the ‘set’ button and the value starts flashing and can be edited.
Use the scroll down button to select ‘METER IMMEDIATE’.
Press the ‘set’ button and the value is saved.
Manual regeneration will start by pressing the ‘menu’ button.”
It’s as simple as that!
Congratulations you have just started a manual regeneration cycle.
Depending on your settings it could take from 30-45 minutes to complete this cycle.
The Regeneration Cycle is complete when the dial returns to the ‘SERV’ position.
Thank you for choosing Water2buy,
Water filtration made easy.