Please respect your local plumbing codes and regulations.
Before installing the water softener make sure you have turned off your mains water.
Push in the plumbing fittings, use silicon around the 0-rings.
Check all 5 red fasteners are present and clipped securely.
Open the bypass valve (Parallel = Open)
Make sure you can reach a power source from your install point.
Connect the waste fitting (A) to the waste. The fitting takes a 15mm tubing.
If your model has an overflow (B) connect to a suitable overflow location separate from the waste. The fitting takes a 15mm tubing.
Note: That 2021 + models of the W2B200 no longer require an external overflow as they are fitted with an internal overflow shutoff valve.
Connected the water feed hose (C) to the Inlet on the water softener, and the return hose (D) back to the water supply.
the IN & OUT flow directional arrows indicate the correct way to connect.
Turn on your water and power.
Check for leaks at all joints.
Inside the salt tank, make sure any internal components are tucked neatly along side the vessel
Fill the tank with Water Softener Salt
Add 4 liters of water to the salt tank.
Check for leaks at all joints every 30 minutes until satisfied that there are no leaks.
Next: Visit Settings Page to generate the optimal settings for your home.
Video: Perform these pre-checks to avoid common problems
Video: Demonstration of installation with plumbing.